Subject: ONE WAY VALVES IN FUEL SYSTEM
From: ACRE NL
Date: 11/9/2001, 7:57 AM


That's why the parallel pumps make more sense to me than the serial
ones.  A simple 'Y' from the gascolator that feeds two pumps, with
another 'Y' downstream to feed the fuel rail, with the pumps
individually switchable.  I would even go so far as to say you need a
dtsp switch so that you can never have them both on at the same time.
Wondering if that came out right. 8-)

Close.  You mean "DPST" (double pole, single throw) switch.

I would argue against that use of the switch, for the following reason: during takeoff
and other "critical phases of flight", you want both pumps running just in case one dies
at the worse possible time.

I had another thought: with the rather distressing number of engine outages early in the
fly off period, I would think that having separate fuel filters in parallel with the
pumps would allow one to detect the "crap in the filter" problem during the run-up:

1. both pumps on

2. engine to high power setting

3. pump #1 off (engine should keep running fine; let run for several seconds)

4. pump #1 on

5. pump #2 off (engine should keep running fine; let run for several seconds)

6. pump #2 on

7. switch to RWS fngine controller side "B" (engine should keep running fine)

8. switch back to RWS side "A"

9. check oil pressure, oil temp, coolant temp, coolant pressure (if you have that gauge)

10. engine to idle, ready for takeoff

Once in flight, switch either the #1 or #2 pump off.  This is for several reasons:

1. you don't want to clog both fuel filters simultaneously.  On the assumption that the
"crap in the filter" is a phenomenon that builds over the course of a few hours (tens),
you want to have assymetric fuel filter run times so that one clogs first and can be
detected on the next run up.

2. either pump produces enough pressure alone.  Running both just heats the fuel
unnecessarily as it is passed more frequently through the relatively hot fuel rail.

3. assuming both pumps have the same failure rate, you want to have assymetric fuel pump
run times so that one fails before the other (minimize the already slim chance of
simultaneous failure).

4. pumps use electricity.  In the event of an alternator failure, having only one pump
running removes a step from the alternator failure checklist.

When preparing for normal landing, switch on both pumps in case of a missed approach.

Russell Kent

The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org