Hans Conser wrote:
Anyone have any thoughts on how I might modify the 13B so the output shaft points straight up?
Hans Conser
That has got to be a bad idea Hans. Worse even than plugs up :-)
I was just reading Kenichi Yamamoto's book Rotary Engine for the umpteenth
time and I noticed this passage on page 34 quote:
"The rotor surface temperature is higher on the leading side due to
differences in burning conditions. The trailing side condition has a great
influence on causing knocking. Therefore consideration has been given to
the arrangement of ribs inside the rotor so that the lubricating oil
will be properly circulated through both leading and trailing sides."
And you want to screw this up by running the engine plugs up or
even worse..... vertical???? :-)
I sympathize with you on the difficulty of designing a low cost helicopter
with a horizontal shaft engine however. How about a car rear axle
hypoid gear set? The Corvette and the Lincoln Mark VIII
have aluminum axle housings. Also the new Lincoln ES and Jag Model S have
aluminum rear axle housings. What maximum gear reduction ratio do you
need? Also as I recall the old Peugeots had a worm drive aluminum rear
axle housing that was probably lighter than any hypoid arrangement.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org