I sympathize with you on the difficulty of designing a low cost helicopter
with a horizontal shaft engine however. How about a car rear axle
hypoid gear set? The Corvette and the Lincoln Mark VIII
have aluminum axle housings. Also the new Lincoln ES and Jag Model S have
aluminum rear axle housings. What maximum gear reduction ratio do you
need? Also as I recall the old Peugeots had a worm drive aluminum rear
axle housing that was probably lighter than any hypoid arrangement.
Paul Lamar
If you would think about a conventional style rear end assembly as being acceptable, then how about one of the many racing quick change rears. They all use 3 inch axel tubes in any wall thickness of 4130 or even aluminum. The Franklin brand use a three bearing pinion like the big Fords. The change gears on a full size unit can withstand 500-600 HP for hours on end. You can have any ratio you want. You can buy one over the phone.
They are all aluminum and may have a magnesium option.
Lynn E Hanover
Great idea Lynn. One could run the pitch change and swash plate control
rods up through the hollow mast (axel tube).
Some of that sprint car stuff is super light and surprisingly
reasonable cost. Also check out "midget" race car quick change rear ends. Plus they
don't use differential gears per se. Something you don't need in a helicopter.
They are usually straight through with locked rear ends.
Hi, thanks for all the great suggestions guys. Paul, you asked what the gear reduction would be, and the answer is we don't know yet, but I can tell you that we are likely looking at a main rotor RPM of 450-600. Tail rotor roughly twice that.
We still haven't paid for the design work because we aren't sure if we are sticking to the original concept of the 4 seat forced induction 20B or not. Twin 13Bs are an option. The homebuilt market seems to be much stronger at lower prices, which is an argument to have a smaller heli with a 13B.
With Mazda coming out with the side port engine soon, we are thinking about putting our efforts into adapting one of thouse smooth rotor housings into a protoype 2 stroke wankel first. Obvoiusly this would be expensive to develop but have an excellent power to weight ratio.
Personally I consider the certified piston (rotary piston in this case) to be worth shooting for long term. Robinson helicopters outsell all other helicopters combined seven to one, they only sell piston engine helicopters. This with outdated two blade main rotor heads.
Hans Conser
I don't think you will get ten to one overall from a quick change rear end
but I could be wrong. Maybe.
2 stroke wankel? Now that I got to see :-)
My gut feeling is you ought to go with a turbo 13B two seat first as
you need to convince a lot of people that a rotary works.
Keep it simple. The simpler the better at first.
You should get better performance than the helicopter everybody will inevitably
compare it to. Mainly the Robinson R22.
If I were doing it I would buy an R22 and install a rotary with a Ford planetary
as a demo prototype. Get some PR on that and sell a bunch of stock :-)
MecanAir will have the rotary certified any day now by using the European loop
hole reciprocal certification agreement with the FAA. Apparently auto engines
can be aircraft certified in Europe. Buy engines from them at first and then set
up an engine shop in Europe.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org