Subject: Oil system mods - Vertical Orientation
From: ACRE NL
Date: 11/13/2001, 8:59 AM


snip...........
I sympathize with you on the difficulty of designing a low cost helicopter
with a horizontal shaft engine however. How about a car rear axle
hypoid gear set? The Corvette and the Lincoln Mark VIII
have aluminum axle housings. Also the new Lincoln ES and Jag Model S have
aluminum rear axle housings. What maximum gear reduction ratio do you
need? Also as I recall the old Peugeots had a worm drive aluminum rear
axle housing that was probably lighter than any hypoid arrangement.

Paul Lamar


Hans,
The 1989 thru 1998 Ford Thuderbird use an alum diff housing as well.  The new Mustang Cobras use this same alum diff.  These are fairly plentiful and cheap in the junk yards if you wanted to consider these.
Ken Powell
kenpowell@aristotle.net


I don't think so Ken. I got a 1994 Cougar and it is cast iron. The Mark VIII is similar
but it is aluminum. If the Mustang Cobras is aluminum it is the Mark VIII part.

Paul Lamar


As I think about this a little harder (oh, that hurts!) I think you are right.  The Cobra does use the Mark diff.
Ken Powell
kenpowell@aristotle.net

The old Cougar and the old Thunderbird use the same parts. On the other hand the new
Thunderbird uses the Jag & Lincoln ES parts. All the same chassis basically.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org