Subject: Vertical Orientation helicoptor reduction box
From: ACRE NL
Date: 11/13/2001, 2:08 PM


I sympathize with you on the difficulty of designing a low cost helicopter
with a horizontal shaft engine however. How about a car rear axle
hypoid gear set? The Corvette and the Lincoln Mark VIII
have aluminum axle housings. Also the new Lincoln ES and Jag Model S have
aluminum rear axle housings. What maximum gear reduction ratio do you
need? Also as I recall the old Peugeots had a worm drive aluminum rear
axle housing that was probably lighter than any hypoid arrangement.

Paul Lamar

If you would think about a conventional style rear end assembly as being acceptable, then how about one of the many racing quick change rears. They all use 3 inch axel tubes in any wall thickness of 4130 or even aluminum. The Franklin brand use a three bearing pinion like the big Fords. The change gears on a full size unit can withstand 500-600 HP for hours on end. You can have any ratio you want. You can buy one over the phone.
They are all aluminum and may have a magnesium option.

Lynn E Hanover

Great idea Lynn. One could run the pitch change and swash plate control
rods up through the hollow mast (axel tube).

Some of that sprint car stuff is super light and surprisingly
reasonable cost. Also check out "midget" race car quick change rear ends.  Plus they
don't use differential gears per se. Something you don't need in a helicopter.
They are usually straight through with locked rear ends.

http://www.1speedway.com
http://www.motivegear.com
http://www.ring-pinion.com
http://www.mspmall.com/beast

Paul Lamar

I've been chewing on this idea for regular a/c, as well. If
you could compensate for the left/right imbalance, it should
make a super cheap, super strong redux for those willing to
sacrifice a little weight gain. I'm too lazy to walk to the
hangar & check, but isn't the 2nd gen RX-7 diff. an aluminum
case unit?

Hmmm, somecars use sideways mounted engines...

Charlie England

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org