Blake wrote:
Loose the V-belts and go with a Poly chain. Interesting to see the
mounting of the 90 degree drive, and the cooling air to it.
Paul, I still wonder if you could somehow get vertical operation of a
rotary.... Hmmmm.
How much is lost in a 90 degree drive in percentage of total power?
Blake, the V belts trouble me too. Every single certified piston engine
helicopter uses them for the tail rotor as far as I can tell. The best kit
heli (the Safari formerly known as the Baby Belle) does NOT use belts in its
drive train at all.
Interestingly, the mechanics I talk to say that the V belt TR drives are
trouble free and very low maintainence. Therefore I'm keeping an open mind
on the Belt drive, but my gut instinct says no to the belts.
Hans Conser
And they absorb torsional vibration. Hard to beat IMHO.
Paul Lamar
Guys, every car out there (or nearly) has multiple V-belt drives for acc'ys.
How much trouble do you have with them? I replace mine every 100K miles
and the mostly look just fine. Check your own experience. They are pretty good
items if used for the proper speeds and HP loads. I don't see a thing
wrong with
V belt drives, assuming you understand and design for the substantial side
loads
that all belts and chain drives cause.
Bill Freeman
Long EZ builder & pilot
BSME, MSME
EAA Technical Counselor
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org