Subject: Rotary helicoptors. V belts
From: ACRE NL
Date: 11/15/2001, 10:47 PM


Guys, every car out there (or nearly) has multiple V-belt drives for
acc'ys.
How much trouble do you have with them?  I replace mine every 100K miles
and the mostly look just fine.  Check your own experience. They are
pretty good
items if used for the proper speeds and HP loads.   I don't see a thing
wrong with
V belt drives, assuming you understand and design for the substantial
side
loads
that all belts and chain drives cause.

Bill Freeman
Long EZ builder & pilot
BSME, MSME
EAA Technical Counselor


Bill,

I agree, they are trouble free for the most part. However, I saw an incident
which kind of turned me off of multiple V belt drives. One of the guys in a
hanger where I used to fly had a trike with a multi V reduction drive. He
was flying along just fine when the spit sponge on his mike came off and
flew back into the belts. It went under the first belt and the whole thing
started shaking like crazy and scared him good. He had to make a forced
landing. Luckily they had just completed a long leg over a remote swamp and
he had a freeway to land on. Further inspection revealed that several of the
belts had walked up on top of their neighbor and chunks were missing from
the aluminum pulleys. The prop shaft was bent and the prop had deflected
forward and hit a portion of the frame. I guess the moral is multi V belts
work fine as long no there is no FOD. Also don't expect to have one belt
break and the others save you. I don't think that redundancy is an advantage
that can be claimed here. If the broken belt gets tangled in the works
you'll have a fun ride for sure.....

Monty


I have always felt that if you intend the multiple V belts to be redundant they
need to be separated by substantial plates to prevent one failure from
leading to the next. OTOH, if they are loaded within design specs, kept
FOD free and inspected and replaced at signs of disress, they are
pretty reliable.  Any PSRU is less reliable than direct drive.  Part not
installed
will NEVER fail.  ;-)  Back to my wish for a large displ, direct drive,
air cooled rotary with a proper propshaft designed in.   Dream on!  But it
is a nice dream.

Bill Freeman
Long EZ builder & pilot
BSME, MSME
EAA Technical Counselor

It would have to be a four rotor Bill as the current combustion chamber is
probably right out at the size limits of practicality. In that case I think
you would have a tough time equaling the current excellent power to weight
ratio. This is intrinsically a high RPM engine.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org