Subject: Rotary helicoptors. V belts
From: ACRE NL
Date: 11/17/2001, 4:07 PM


Patrick Stapelberg wrote:

I Close friend of mine once flew into a rain storm with a multiple V- belt
drive on a ultralight, the wet pulleys started to slip  and the two stroke
engine started screaming.The pilot opted for a dead stick landing.One
wanders what a burst or leaking oil line will do.
Patrick


The R22 uses two double vee belts as a clutch, approx. 0.8:1 reduction. between
engine and drive line. They are protected from the weather under the cowl, but
are fully visible; ie. not enclosed. Tensioning is by load sensitive linear
actuator between bearing on engine crankshaft and bearing on drive line, the
engagement taking about 30 secs. The drive line pulley is fitted with sprag
clutch for auto rotation rotor freewheel. When the engine stops you have 1 to 2
secs to get the blades freewheeling and the collective full down- no blade
pitch. During flight the clutch actuator light shows that the unit is keeping
the correct tension. From this operational knowledge I suggest that a variable
centre distance or other automatic tensioner may be necessary for a vee belt
drive with close centres, particularly if the ratio is large: ie. having a small
pulley with limited wrap. The pulleys heat up, the belts heat up, the rain
lubricates the belt, the temperatures change, then slipping. Helicopters have
engine and rotor tachs showing both on one display. Good idea.

Colin

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org