<< Now before this I did not like cad plating because of the hydrogen
> embrittlement however after I have researched it and talked to people
> I am sold on it and I am going to plate the parts on my new Coot. But
> you must go to a shop that does certified aircraft plating and tell
> them it is for aircraft. A good way to find one is to go to a prop
> shop and ask who plates their parts.
> One last note and that is no blame can be put on the people that
> built these coots. They took their parts to cad shop so they would
> have a better airplane. It is the cad shop that screwed up.
> Ken Welter
Powder coat parts. It is safer. If you don't like powder coat
(some worry that it hides cracks) paint them with epoxy paint.
Paul Lamar
That is one evil design, and poorly welded as well. The urge to protect
against corrosion in a seaplane is understandable. I think that some parts of
a flight control system should be removed and Magnafluxed on some time basis.
To that end, plating is not approved. Another tack might be a thin coat of
zink chromate. Good protection and still will show a crack. Easy to remove
and replace. Makes things look like airplane parts.
Lynn E. Hanover
Aren't they supposed to be airplane parts ???
Isn't that what we are talking about ??
/Martin
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org