Subject: peak engine torque verses "max available torque"
From: ACRE NL
Date: 11/18/2001, 9:17 AM

Charlie and Tupper England wrote:


lots of snips.....

copied:
in amateur road racing. If one had a infinitely variable ratio transmission
one could operate the engine at peak HP RPM all of the time and one would
have max available torque all of the time. <PL>

I hope that you mean that you could pick one of two RPMs &
have EITHER peak HP all the time or peak torque all the time
(but not both).

Charlie


 I'll see if I can word this some other way.

Lets say HP is max and RPM is 6000 and engine torque is 100 foot pounds at 
that RPM and HP. Lets also say the peak engine torque is 120 foot pounds at 4000 RPM.

The engine torque however is multiplied by the over all gear ratio.

To keep it simple lets say the car was going ten feet per second and the drive wheels 
were ten feet in circumference.  The rear axle is therefor rotating at one 
revolution per second. The engine RPM at max HP is 6000 RPM or 100 revs. per second. 
The overall gear ratio required is therefore  100:1. 

100:1 gear ratio with 100 foot pounds of engine torque gives
10,000 foot pounds of torque at the rear axle at 10 feet per second
and one rear axle rev per second.

At 4000 engine RPM or 66.66 revs per second the gear ratio must be 
only 66.66:1 to get 10 feet per second or one rear axle rev per second.

So rear axle torque at this engine RPM would be only 66.66 times 120 foot pounds
or only about 8000 foot pounds so the car acceleration would be much less.

Therefore it is better to run the engine at max HP RPM all of the time
and get the "max available torque" you need by changing the gears.

If you are a road racer and it is allowed by the rules optimize the
engine for max HP and put your money into a six or more speed gear box.
Forget low RPM torque. HP is what makes your car accelerate.

What I should have said was "max available torque at the rear axle".

Here is a little quiz:

I have an airplane with 200 pounds of drag flying at 200 MPH.
What is the net HP coming out of the prop?
What is the engine torque?

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org