Subject: rotary power to weight ratio
From: ACRE NL
Date: 11/19/2001, 11:14 AM


Curtiss-Wright built rotaries in more sizes than anyone else -- from 3 cu.in. to 1920 cu.in. per chamber. Their approach was to keep apex seal sliding speed constant regardless of displacement. Seal sliding speed is linearly related to the crank eccentricity, while displacement is a cubic function (I believe -- please check me with the displacement equations that I don't have at my fingertips). Therefore, doubling displacement will not result in a halving of design engine speed. In my experience, the power to weight ratio can be held more or less constant within reasonable limits of displacement for the same number of rotors. As an example, the CW/Deere/RPI 350 cu.in. (5.8 l) per rotor engine (more than eight times the displacement of the 13b) weighs about 1700 lbs, produces about 1200 hp at 3600 rpm (diesel fueled). A gasoline engine could be made significantly lighter. There may well be practical limits to combustion chamber size for gasoline, additional spark plugs might help to create the kind of flame front required. I would GUESS that a gasoline engine roughly double the displacement of the 13B would be very practical, with a crank speed of about 5000 rpm, good power to weight ratio. You are correct that RPM has little weight impact, and the lightest possible theoretical rotary engine would probably be a small displacement, high speed, multi rotor (4, 5, 6...). This is very analogous to why the older exotic high power engines were small displacement per cylinder V-12s -- high rpms were more readily acheived with many small pistons rather than few big ones. The penalty is cost and friction.

Jon


 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org