Blake,

You meant hole number 7 (number 4 on Tracy's drawing) and my mistake in
the chart on the right. I copied the chart incorrectly from Tracy's
dimensions drawing. Had me confused there for awhile.

The proper location for hole number seven on my drawing
is 226 degrees 5' 56".  That would be hole 4 on Tracy's drawing.


Don't drill the 10 mm holes. I will fix things on my drawing soon.
I will go back to Tracy's numbering system for the holes
to reduce the potential for this kind of confusion.

This lack of dwg file compatibility is as bad as going to Mars
using the metric system instead of inches. :-)>

Paul Lamar

Come on Paul, quit unfairly beating up on the metric system. If they would
just pick one or the other rather than two separate unit systems, it would
have went fine. Management problem not units. {;^)

Monty

OK I give up! Hold those cards and letters on the French system verses
the English system :-)>

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org