Subject: Thick heat exchangers/ oil coolers
From: ACRE NL
Date: 11/23/2001, 6:26 PM

Here are the curves for a roughly 7 by 8 by 3.5 inch
cooler. I recommend everybody go through the exercise themselves.
Figure 100 MPH and six inches of water.
Roughly 4000 BTU/min for a 20B and 2700 BTU/min for a non turbo
13B is needed. Enter the air side chart  at six inches of water
and take the pounds of air per minute into the heat chart and read out
the btu/min on the left side for what you figure the oil flow rate
is. Real simple. No mystery here.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org