This is a chart of the fatigue characteristic of various
materials as a function of temperature.
Note that air cooled aircraft aluminum cylinder heads are operating
right at the edge of fatigue failure all of the time. This
may be true for parts of the pistons as well. So too perhaps
is the rotor housing at the base of the spark plugs where the
temperature is the highest. That is why some people have seen cracks
in the rotor housing at this point. The steel liner helps of course
but we need a thermocouple in this area to be sure we do not exceed
the temp limits of aluminum at whatever power levels turns out to
be the max continuous for the rotary. Right now we think it
is at least 150 HP continuous but it may be more.
Note also that the steels used for exhaust valves have no flat spots
in their curve so they will fail sooner or later no matter what.
This also illustrates why titanium valves are not the hot tip.
The 4340 is high quality crankshaft material and if the stress is
kept at a rather low for steel 55,000 psi it should last for ever.
Obviously that would make the crank too heavy for an aircraft engine
so a higher stress level must be present. This is probably the stress
level a truck engine designer would strive for. The max stress
for this material is up around 200,000 psi and that perhaps is the
number a car race engine designer might use.
Chart by Taylor.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org