Any PSRU is less reliable than direct drive. Part not
installed
will NEVER fail. ;-) Back to my wish for a large displ, direct
drive,
air cooled rotary with a proper propshaft designed in. Dream
on! But it
is a nice dream.
Bill Freeman
Long EZ builder & pilot
BSME, MSME
EAA Technical Counselor
It would have to be a four rotor Bill as the current combustion
chamber is
probably right out at the size limits of practicality. In that case
I
think
you would have a tough time equaling the current excellent power to
weight
ratio. This is intrinsically a high RPM engine.
Paul Lamar
Why intrinsically high RPM, except due to low displacement? What
about
the 21A or the huge pipeline engines? I can't see why the size
can't be
increased
and keep the "excellent" (?) [good, perhaps] power to weight ratio.
Bill
Long EZ builder & pilot
BSME, MSME
EAA Technical Counselor
I think the pipe line engine had BSFC and detonation problems with that
huge combustion
chamber. I could be wrong on this. Perhaps a sphere's surface area to
volume ratio
may get more favorable as the size increases.
I think it would be hard to make a large low speed rotary with the same
power
to weight ratio as a high speed rotary. Power of course is proportional
to
displacement
times RPM. If you halve the RPM and double the displacement you will
wind
up with a heavier rotary I suspect. RPM weighs nothing. With a piston
engine
on the other hand high RPM is less desirable as the reciprocating loads
rapidly
increase with higher RPM's.
What do you think about this Jon?
Paul Lamar
I rarely hear about the gear reduction on the PT6 failing at all. Or any
of
the turboprop units. And that engine turns at 40,000 rpm then reduced to
2200 rpm or so. So whats the problem? Nice power to weight too. Too bad
the
fuel burn is what it is.
Marc Wiese
The major difference in turboprops is that they have a continuous torque,
stable throughout the rotation, whereas the internal combustion engines have
pulsating torque for the combustion cycle. Hence, there is cyclic loads on
the gear.
It could even be so bad that the torque reverse for a small segment of the
rotation, during which time it is the inertia of the prop that maintains
rotation.
Repeated cyclic loads 2500 times per minutes makes a lot of strain on the
gear. It is like hammering on the gears 40 times per second.
Rgds
Philippe CHENEVIER
So true.
Fortunately the torque load in a two rotor wankel does not reverse unlike
a four cylinder piston engine. The other thing we have going for us is
the rubber torsional isolator Tracy puts in his PSRU's between the e-shaft
and the sun gear.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org