Delbert Johnson wrote:
I called Tracy Crook this morning to brainstorm an idea that I had to
install a small radiator in the oil pan to provide initial cooling of the
oil and to increase the difference in the water to air temperature for more
efficient cooling. The idea is similar to Tracy's copper pipe system but
with improved efficiency.
The concept begins by using a thick enough piece of plate aluminum that can
be used as a motor mount and can be bored and taped fittings for water
in/out ports. This plate will go between the block and the oil pan. The
interior portion of the plate will be milled down where the thickness is not
needed for structural support and a small radiator would be installed in the
center portion of the plate (accommodations would have to be made for the
oil pickup tube). It may be possible to use one of the radiators with the
plastic header tanks, remove the plastic portion and weld it to the aluminum
plate. The coolant ports could pass through the aluminum plate material to
the exterior of the engine. This would be similar to Tracy's steel plate
with holes in it for passage of the oil. The difference is that oil would
pass through the radator that is integrated into the inner portion of the
plate and that the alluminum plate would lower the oil pan another +-1/2
inch. I hope I'm making sense.
If this doesn't suffciently cool the engine then one of two solutions could
be used: (1) install an oil filter/oil cooler combo and run coolant from
the outflow (cool side) of the radiator through the unit or (2) install
copper coils or a second mini-radiator in the bottom of the oil pan and feed
it with the outflow side coolant. The latter option may require a
redesigned oil pan especially if the second radiator is installed.
The benefits of this approach are:
1. More efficient cooling ( higher coolant temperature, higher air to
coolant temperature differential).
2. Elimination of the external Oil Cooler and associated weight.
3. Elimination of long external Oil Hoses to/from the Oil Cooler.
4. The Alluminum plate doubles as a engine mount base using a Mike Wills /
Perry Casson style mount.
Ok... Is this feasable? I need to search for those mini-radiators. If
anyone has suggestions pass them on.
Also, I may need some help on the heat transfer physics to determine how
much heat can be pulled from a small radiator. The engine that I am working
with is the 13B
Delbert Johnson
Just remember there is no free lunch. You will need a water radiator
one third larger. There is no cooling but air cooling.
Therefore I see no advantage to this. I can see several disadvantages
such as cost, time, less room under the engine for the water
rad and maybe a few others. A major factor is the lower delta T between water
and oil making the exchanger less efficient. The unknowns make it inadvisable.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org