Blake Mantel wrote:

Paul, can you do up one more IGES file with the part, front side only, no dimensions, with the current data. I will do a data check and post process off of that one.

Blake

I give up Blake. As far as I can tell there is a serous bug in the point
command of both ACAD R11 and ACAD R12. I can not do an exact scale drawing. 
Forget the bell housing bolt holes. Do the counter bore and the pockets and 
the big starter hole. I will match drill the bell housing bolt holes
from Tracy plate and I know that fits.

You could put the holes in manual G code from the attached Weichman drawing
if you want. I checked the angles and they seem to be OK.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org