> >Ken Welter wrote:
>>
>> I have my coot at home to work on it for a month or two and one of
>> the things I am going to try is installing a 80000 BTU fluidyne heat
>> exchanger and have a separate radiator for it and a electric water
>> pump for the system and have a valve so I have the option to tie it
>> into the engine system. I tried the fluidyne cooler before and it
>> shot the water temp out of site. I have put a larger radiator since
>> then but I still want a separate system. Does any one know of a
>> electric water pump that would do the job.
Ken,
The power consumption for a water pump for primary engine cooling
is too large to make an electric pump practical, esp in an aircraft.
Basically, you have to convert the shaft hp to electricity, transport it
and then convert the elctricity back to shaft power. For small loads
this is lighter and simpler than shafting and belting. For large loads
the size of alternator and motor are very large and heavy. Bad application
for an electric water pump. I'm afraid the best bet is the original pump,
altho a viable alternative is a totally external belt driven water pump,
available from racecar suppliers.
Bill Freeman
Long EZ builder & pilot
BSME, MSME
> EAA Technical Counselor
This pump is not going to be used as the primary pump the stock
pump will be used for the water cooling the engine and the electric
pump will be used for a separate system useing separate radiator and
heat exchanger and I don't think it will take that big of a pump to
do the job however I may consider the belt pump but that would be a
big problem on where to mount it as I have two alternators and space
is limited.
It will still need to be around one HP Ken.
At 746 watts per HP and 14 volts from the regulator that
will be at least 50 amps additional out of the alternator.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org