Subject: Dual cooling example: Was; The potentail of the wankel.
From: ACRE NL
Date: 12/2/2001, 7:22 PM


Tom Kendall wrote:

<Snip!>

Bill's posting of the various ring type radiators got me thinking (and out
of lurking!).  I've been involved in the specification & installation of
some large industrial cooling radiators over the last few years, and part of
that involved going to inspect the fabrication facilities, tooling, process,
etc.  The techniques are Interesting, but definitely out of the range of
what most homebuilders (even those on this list) would want to tackle.  Not
particularly complicated, just capital intensive.

All of the ring rads shown below are impractical for one-offs... except
maybe the drum type.  In that case, it looks to me like a "pseudo"-drum
could be made by placing several small rectangular coolers (automotive a/c
evaporator coils?) in a circle around the PSRU.  The airflow could be radial
from the "inside" of the drum made to the "outside" of the drum (but inside
of the cowl).  For optimum drag reduction and effectiveness, it looks like
the spinner should be a bulbous one that actually starts slowing the
incoming air before it gets to the cowl inlet.

The small individual rad segments certainly couldn't handle the full cooling
flow, but ring supply & distribution headers shouldn't be too hard to
braze/silver solder together.  AN fittings at each segment... could be very
inexpensive for materials, and quite effective for cooling.  One or two
segments might serve as very effective oil coolers with the rest being the
water radiators.  This should give a very stream-lined cowl, and permit the
use of thin rads while still getting a pretty large heat transfer area.

I don't have any figures for the sizes involved, but for Tracy's PSRU,
there's probably about 8"-10" of stand-off to fit rads.  Assuming an 18"
diameter ring/drum, that makes for a face area of ~3 to ~4 square feet.
Seems like it's in the ball park.

Problems could be things like difficulty in installation/removal for
servicing the engine and/or PSRU (probably have to remove the prop and take
the rad assembly off the front), attachment of the forward cowl to the main
cowl body, mounting of the rad drum (to the PSRU adapter plate?), and any
air requirements for ventilation of the engine comparment itself.  But
perhaps all surmountable.

Whaddya think all?  Is this one worth kicking around any further?

Tom Kendall

The Do-335 was one of the fastest aircraft of WW2, which tends to
indicate that it had a very good cooling system, drag-wise.  The Germans
used the ring cowl on a number of different designs and these guys
were nobody's fools.  My guess is that the ring cowl is the lowest
drag for a front radiator, but (as usual) the devil is in the details.

A segmented radiator should work, you'd need shock mounts and
you'd want cowl flaps.  The ring-type cowl flaps looks like a lot of
work, but they are obviously do-able since all radial engined fighters
had them.

Have at it.

Bill Freeman

Here is a picture of a segmented radiator on a Orenda V8 powered
King Air.

Paul Lamar

Ops the picture did not go out. In fact I thought I had a picture
scanned but apparently not. I do have a picture around here somewhere.
Forget the picture :-)>

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org