Jerry Hey wrote:

I finished the swirl pot yesterday.   All that remains for the
cooling
system is the overflow tank which I think I will make out of welded
aluminum.  Is there any problem with having it fill and empty from
the
bottom?    Jerry

Nice photograph Jerry. What is that oil cooler doing near the
firewall?

That is where mine was originally. It did not work!
Ian RV6A.

I'll reserve judgment until I see what the scoop and duct look like :-)

Paul Lamar

I am planning to pipe the air in from the front of the cowl,  probably
3" round inlet.      Scat to intake plenum.   Air exhausts  at bottom
of cowl.

I would welcome anyone's recommendations for fitting an air cleaner and
intake.

    Jerry

That sounds good Jerry. Be sure and make the transition from three inch
round SCAT to the cooler bell shaped.
Here are the coordinates again for the new guys.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org