Subject: Mechanical tach's. and TES o-rings
From: ACRE NL
Date: 12/16/2001, 12:24 AM


paul, i belive that each tach has its own ratio stamped or imprinted on its case some were. as each engine type may have a different drive ratio. tom kimsey

also their is another gentelman on our list who signs his e-mail as tom k. i would appreciate it he would include his last name so as not to be confused with me. thank you. please see the attached photo of the teflon encapslated silocone o-ring damage to my engine that i was discusing with you at the gathering at Tracy's house. I asked you in a later e-mail if you remembered the part number of the ring that you sent to me( outer coolent) and you told me that you could not remember or had lost that information. I believe that the TES o-rings are a worth while improvement to this engine and ended up using the TES o-rings at the inner position and using the stock Mazda rings at the outer after i discussed this with Bruce Turrentine. I have some more jpgs of the damage to my front and rear side housings if you would like to see them. Tom kimsey

 [Image]

That is real strange looking Tom. Did the silicone part extrude itself out
of the teflon cover and into the crack? I can't for the life of me understand
how this happened. Perhaps there was a core shift in this casting that left
a very thin amount of metal under the O-ring groove. Can you take another
close up picture with the O-ring removed and the two cast iron parts
removed so we can see the floor of the O-ring groove?

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org

Tom-Kimsey-O-ring.jpg