Tracy, please tell us more about your experience with avgas
versus
mogas. I'm very concerned about a turbocharged auto engine
needing 93
octane unleaded, running avgas in a pinch. Others say that the
O2
sensor will plate over in short order (1-2 hours?) and stop
working,
leaving the engines to run in open loop mode. They also say the
only
way to remove the lead from the O2 sensor is to replace it or
run a
propane torch over it for 15 minutes or so. Neither of these
has been
your experience? How many times have you had to use avgas when
you
couldn't get mogas? I'm concerned that ANYtime I'm away from
home or
relatives areas that I'll wind up having to use 100LL. I have a
25
gallon tank Mustang II. Good info about the plugs, too. They
are a
pain to get to, but changing them is certainly easier than
changing the
O2 sensor!
Thanks,
AI Nut
Not much to tell beyond what I said above. As far as the fear of
going open
loop when the O2 sensor gets lead poisoning, my advice is DON'T use
a closed
loop EFI system using an O2 sensor in an airplane. I use an O2
sensor only
to monitor mixture, not for feedback to the EC2 controller. I've
used
100LL on one or more legs on virtually every long cross country
trip. It is
not uncommon to find that mogas airports are out of that fuel.
Plugs hard to get to? Put a higher priority on maintainability when
designing your installation :-)
Tracy Crook
tcrook@rotaryaviation.com
www.rotaryaviation.com
>From what I found out today, the O2 sensor will be mounted in the turbo
exit body, so it will be very easy to get to.
Don't use the O2 sensor to feed the computer? Won't mileage suffer, as
well as incomplete combustion causing potential engine harm? If you
don't use it, what value resistor do you use to feed the computer, if
anything? This is an idea that has not occurred to me. Seems like it
would shorten engine life and make plugs foul quite early.
AI Nut
Tracy is too modest to explain to you that he designed and builds the
computer for
most of us putting rotary engines in airplanes. It does not use the O2
sensor. It is
open loop and uses only intake manifold pressure, RPM and intake manifold
temp to determine the correct mixture. It works very well indeed and is
totally
redundant for reliability while being very reasonable in cost.
BTW shame on you Mr. Nut for not educating yourself by reading both
the ACRE NL web site and Tracy Crook's web site which the
address can be found on the ACRE NL web site.
Paul Lamar
Thanks for the plug Paul :-)
After working on the EC2 and using O2 sensors to monitor mixture, I learned
an interesting point. The center range of automotive O2 sensors is useful
for only one thing - minimizing EPA defined emissions. Contrary to popular
belief, this does not give best power or best fuel economy. At takeoff
setting on the EC2 (best power) the mixture is near the top of the scale.
At best economy setting (cruise flight) The O2 mixture monitor is off the
bottom of the scale.
Tracy Crook
tcrook@rotaryaviation.com
www.rotaryaviation.com
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org