mike h wrote:
The center range of automotive O2 sensors is useful
for only one thing - minimizing EPA defined emissions. Contrary to
popular
belief, this does not give best power or best fuel economy. At
takeoff
setting on the EC2 (best power) the mixture is near the top of the
scale.
At best economy setting (cruise flight) The O2 mixture monitor is
off the
bottom of the scale.
Tracy Crook
tcrook@rotaryaviation.com
www.rotaryaviation.com
Tracy,
Is this a limitation of the dynamic range of the O2 sensor itself or
is
the limitation imposed by the monitor that receives its input from the
O2
sensor? If its the latter, seems to me it would be worthwhile to design
and
build a better monitor to take full advantage of the full dynamic range
of
the O2 sensor.
Mike Wills
Hey all look at the following site:
http://www.techedge.com.au/vehicle/wbo2/default.htm
They have redone the board originally designed for the DIY-EFI list
http://diy-efi.org/diy_efi/projects/diy_wb/
and also a PIC-based ratio display. I have 2 of the original WB boards, and
I'm waiting on the funds for the Honda sensor. I ordered the TechEdge
modified display kit, but haven't received it yet. A friend and I are
reengineering it to use a different PIC that will allow us to output a
serial data stream as well as the indicator to datalog with a PC, although
you could use the joystick port and a lookup table to do the same thing.
This seems to be a much better solution that relying on the standard
'switch' lambda sensor for tuning info. It has a built in heater and control
circuit, so it should work fine at altitude too. Best of all it's not $600
like the Motec sensor by itself.
Mike Harrington
Caution. The wide range sensors will also be disabled by 100LL
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org