Delbert Johnson wrote:
Does anyone know what the coolant and oil flow rates in the 13B.
I'm still pursuing the idea of cooling the oil with the coolant by passing
the oil across the fins of a small radiator mounted in a modified oil
> pan.
Delbert:
>From dyno data that I have, the oil flow was (RPM/ gpm)
1500 / 3.5
1800 / 4.1
2500 / 5.6
3000 / 6.5
3600 / 7.3
4000 / 7.8
4500 / 8.1
5000 / 8.1
If you plot this you'll see this asymtotically approaching a max a little
over 8. I think this means that is about all the pump can force through the
engine. Don't know whether your engine would be the same.
Cooling the oil by some means other than just flow through an air cooler has
merit in the case where the flow you get in the oil loop is too low to carry
the heat without an excessively large temp drop across the cooler.
Apparently not be an issue with a NA 13B, but clearly is an issue for a
turbo 13B or 20B. For near optimum cooler design on my 20B I would need an
oil flow of 16+gpm at 6000 rpm. That's why the racing guys run loose
bearings, or do other tricks to increase oil flow.
Al Gietzen
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org