I have to ask, why not use a egt and fuel flow meter/ Tells you so much
more.
like your hp at any given rpm range. And by the way 100LL is death to a
rotary. You should see the inside of one. But using once in awhile
changing
the spark plugs work and adjusting your egt and rpm you can easily burn
the
lead out. The term 100 low lead is grossly miss leading. I've
disassembled
engines (new ones) just to check this situation after just one cross
country.
I come from the seventy's rotary's when a tune up was to remove the
spark
plugs blast them with abrasive and go run the car hard down the Calif.
freeway and hand it back. The newer engines are more tolerant than the
old
ones. But fuel flow and egt tell you so much at at glance. Never have
used an
o2 sensor for the very reasons you guys are discussing. Tracy's
injection is
perfect for what I'm saying. Hey I'm just asking why have an o2 on
board?
Skip
Hi Skip,
I fly with the 02 sensor, EGT gauge and Fuel Flow meter and ideally I
think you should have all three. I flew at first with just the EGT and
while it would indicate gross conditions, the response time was slow and
small changes hard to assess. I added the 02 sensor which provided an
almost instantenous indication of what was happening (too lean, too rich,
just right, etc). Adding the fuel flow meter then provided even more data
related mainly to power production. All three instruments provide useful
information and I think that together are ideal. I know that at take off
power if my AF is not indicating "Best Power" and the fuel flow is not at
least 15 GPH then I need to check things out.
Thats my take on the instruments FWIW.
Ed Anderson
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org