snip

Well I suspect we could sell at least ten right off the bat at about
$300 to $500
US. Long term in the next ten years a growing number. Since the
currency down
there is so favorable do you have any email addresses of pattern makers
in Aus
that I can email drawings to for quotes? I sent out some request for
quotes to the UK.

The runners would look something like this only shorter to keep the
size of the
pattern down and make the manifold tunable. The casting themselves cast
in the US
here in So Cal are not much.

You can put me on that list Paul.  I am not happy with my present
intake although I have not  yet proven it won't work.   It came with
the engine.    Short runners coming out of a plenum.  Is there any
hope for such a configuration?    Also, does it matter which end is
forward on the fuel rail?    Jerry

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org