Tom Kendall wrote:
Woke up this morning and had a flash of insight. Before the sun was up I had created a couple of "shrink rules" for use in laying out the casting patterns. Beats the heck out of paying $80 a piece for 'em! Also ordered a couple of specialty hand tools for carving out some of the curves, nooks, and crannys. Always can use a few more tools around here :-)
I've been checking on the various aluminums that might be used to cast these beasts. Fortunately, the decision doesn't need to be made until much latter. But it's food for thought: Is the ability to weld anything to these a concern? Picking the right alloy will permit it, but at the expense of castings that will have to be heat treated. Otherwise, it looks like a 535 aluminum would be most suitable: easily machinable with good corrosion resistance. It'll also take a polish or anodize if anybody has nothing else to do with their $$ and wants their engine to look like jewelry. Reasonably strong (18 ksi yield stress) with lower thermal conductivity than most aluminums (but not a whole lot less).
Somebody was asking about fuel injectors on the manifold. While I realize that this is a no-go for turbo installations, if we wanted a "universal" manifold I could probably put some bosses on the manifold for the N/A folks to drill, tap, and otherwise use for their injectors. Come to think of it, I might be able to make the bosses on the pattern removable so that they could be cast with or without the bosses. If there is interest in this, I need to know details of what to and what not to do. The injector bodies would have to be horizontal (vertical faces on the bosses) to work with the pattern I'm designing. Are there other attachment points needed for things like the fuel rail, etc?
By the way: just signed myself up to take delivery of a 20B twin turbo in a month or so. Supposed to be a "low milage" used engine from Japan. Getting it through Japan Direct. Anybody have experience with them?
Next project: Make a set of patterns for my 20B's manifold!
Tom Kendall
As long as the injector bosses can be hack sawed off to clear the turbo I have
no objections. I personally will mount my injectors over on
the cool side of the engine. Nothing worse than an in-flight fire IMHO.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org