Subject: 6 port to 4 port (was intake manifold)
From: ACRE NL
Date: 1/6/2002, 11:21 PM


This is going to be strictly a four port unit for now, yes?  Any chance
there is going to be enough meat on it to reach out and cover a six
port?  I believe this was discussed once and the answer back then was no.

With the engine I'm working with I will probably just do up a custom unit
as I don't think there are many out there looking like this.  The Racing
Beat 4 barrel Holley manifold (for sale) that was on it used this adapter
plate that I just can't bring myself to use.  The flow characteristics into
the end sections must have been horrible.

You can see here why I want to take advantage of a 2.85 drive.  This thing
should be able to breath well with the right NA induction system.  I'm
leaning towards a 55 mm TWM ( http://www.twminduction.com ) m/ 2900
throttle body with ports for all four injectors.  TWM has some nice looking
off the shelf / off road throttle body components, albeit a bit pricey.

This engine was originally built by Rob Golden of Pineapple Racing in
Portland, OR.

Mike McGee, RV-4 N996RV, O320-E2G, Aurora, OR
13B (MMini-Rocket) in gestation mode


Super cool Mike. I am happy to see that someone is finally trying
to convert a six port to a four port. Good work. I think it is going
to set a record for HP from a side port aircraft engine. Great.

Ok Tom this is why we need plenty of wall thickness meat around those
intake runners so people can port the manifold for this level of engine
porting.

Paul Lamar


I can't take credit for the "idea".  Rob Golden has been doing these for
quite a while, probably a few other racers as well.  I found the motor like
this last summer.  I bought it from a quarter mile racer who was switching
over to small block Chev.  If I remember right Golden said that with the
right breathing it should be good for 210 or 220 HP @ 8000-8500.  I'm
anxious to see what it does.  I'm looking for a 6000-6500 cruise and
7500-8000 balls-out with a 2.85 gear.  I'm planning to have at least 10
hours on a test stand before the Lyc comes off the RV-4.  I should be able
to get a torque curve plotted up to static runup with the prop on it.
Mike

Mike McGee, RV-4 N996RV, O320-E2G, Aurora, OR
13B in gestation mode

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org