Subject: Velocity PowerSport rotary air scoop
From: ACRE NL
Date: 1/6/2002, 4:43 PM

Joe Schiferl wrote:

HI Paul --  Your name was given to me by Greg Richter. I'm building a Velocity 173 RG
and have a PowerSport rotary engine in it. I'm looking for information on design of a
P51 type air scoop. Would you be so kind to send me on the design of the scoop. I would
also like the rotary listserv. that Greg was talking about. He says you are all a bunch
of good guys who know your stuff. Thanks for any help or direction you can give me.
Best always  Joe Schiferl


Welcome to the list.

Make the outside look just like the P51. It is the inside that needs to be shaped
differently than the P51 scoop. It needs a bell shape where it connects
with the radiator. Here is the basic idea. Use a thin radiator under the
engine something like this. The picture is of a duct that fits well albeit
a bit small for a Power Sport 215 HP engine. This is also a simple wedge shape
duct but a curve as shown in the sketch will work better. The rad should be
about 16 inches wide by about 24 inches long and about two inches thick
maximum. This thinness is absolutely necessary so the airplane cools well on hot
days while climbing out at 120 MPH or so with very little dynamic air pressure 
to work with. A rad too thick defeats the purpose. Better to make it wider
or longer.

Don't try to use an oil water heat exchanger as that can make the cooling
system unstable and marginal. Better to have a separate cooling system for
the oil so if one fails the other will help keep the engine cooler.
Use a stock RX7 2nd gen oil cooler along side the rad shown in this position. 
Very critical to cool the oil properly. If the oil still does not cool
use two stock coolers. One on either side of the rad.

Feel free to ask any questions that come to mind.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org