<<<snip>>>
Also, how would I get my iPaq Pocket PC to run both Anywhere
Map and
log data from
my engine monitor at the same time?
Finn
Finn,
I built a little PIC circuit that lets me send rs232 data into the
Ipaq via
the infrared port (the IR port looks like any other rs232 port to
the
software). I have not gone much farther than proving I can get a
GPS and a
simulated EC2 stream into the IPAQ via the IR port when I went back
to
working one more pressing issues like get this thing flying. Let me
know if
you want more details.
Perry Casson
We are into details around here Perry.
Paul Lamar
Yes, details, this is just the thing I've been wanting. Snap the iPAQ
into
its holder and it will do GPS and DAQ (I think we've combined threads
here). I ran the Anywhere map all the way to Venezuela and back in the
RV-4 and loved it. Now if I can get the engine data recorded on the
same
unit it would make performance development a snap. Throw in a couple of
channels for pitot & static pressure and we've got a full up performance
analysis unit that spits out a spread sheet.
Mike McGee, RV-4 N996RV, O320-E2G, Aurora, OR
13B in gestation mode
Attached is the circuit I built, it really was to do three things,
1 Provide DC power for my etrex GPS (3.05V)
2 Provide DC Power for the IPAQ ((5.0V)
3 Read NEMA 0183 data from the GPS and info from Tracy's EC2 and send them
both data streams to an IPAQ via the IR port. The code in the PIC 16F84 was
reading both inputs at 4800 baud and tx-ing to the Ipaq at 19.2K using some
bit banging code based on some stuff written by Robert V Ammerman.
By combining the two data steams pretty much meant I would have to write
custom software on the IPAQ for both the GPS and Engine display stuff. I'm
feeling less ambitious now and think I'll just send the GPS data in via the
hardware port and use Anywhere Map. Getting the EC2 data in via the IR port
using this circuit is still an option but the guys at Grand Rapids
Technologies are going to add support for displaying EC2 data on their EIS
display so it's not such a priority for me now.
I think there was one tiny difference between regular RS232 serial and IR
signals but be damned remember what it was (IR on = V-???). I didn't put
much for comments in the PIC assembly code I was using for testing but I'll
take a look at it this week to try to figure out what was going on.
Perry Casson
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org