Subject: High engine revs (was - 6 port to 4 port (was intake manifold)
From: ACRE NL
Date: 1/8/2002, 12:32 AM


I can't take credit for the "idea".  Rob Golden has been doing these
for quite a while, probably a few other racers as well.  I found the
motor like this last summer.  I bought it from a quarter mile racer
who was switching over to small block Chev.  If I remember right
Golden said that with the right breathing it should be good for 210
or 220 HP @ 8000-8500.  I'm anxious to see what it does.  I'm
looking for a 6000-6500 cruise and 7500-8000 balls-out with a 2.85
gear.  I'm planning to have at least 10 hours on a test stand before
the Lyc comes off the RV-4.  I should be able to get a torque curve
plotted up to static runup with the prop on it. Mike

Mike McGee, RV-4 N996RV, O320-E2G, Aurora, OR
13B in gestation mode


Lynn, Skip and other experienced / racer guys,
I plan on turning my PP engine up to 7400 rpm.  I understand that I need stationary
gears from a '89 or later.  Does the engine need other mods (balancing, the special
bearings, etc) for this RPM level?  How about 8000 - 8500 rpm as Mike suggests?

Thanks,
Ken Powell

The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org