Subject: High engine revs (was - 6 port to 4 port (was intake manifold)
From: ACRE NL
Date: 1/8/2002, 9:40 AM


Lynn, Skip and other experienced / racer guys,
I plan on turning my PP engine up to 7400 rpm.  I understand that I need stationary
gears from a '89 or later.  Does the engine need other mods (balancing, the special
bearings, etc) for this RPM level?  How about 8000 - 8500 rpm as Mike suggests?

Thanks,
Ken Powell


Nothing up to 8,000 RPM. At that point I would add a windowed rear stationary gear bearing, racing rotor bearings and a racing oil pump. The noise at full throttle will be amazing. As will the fuel flow.
I would avoid operation above 7,500 RPM for long life.
Mine and the engine. The heavy 13B rotors won't take the revs like a 12A, but my friends are turning them above 9,000 every weekend for 45 minutes. There are however failures every week. The rotor bearings pack up from overstress. Fatal to the engine and very costly.
In the improved touring class, where you are limited to the stock rear end gears, the RPMs are down around 8,500 and the engines last for years. Oil has to be cooled to say 160 to 180 degrees. Bearing strength goes away quickly above that. Water not over 190 degrees. Oil pressure, 75 is good 95 is great. Over 9,000 RPMs 95-110 PSI is better.

Lynn E. Hanover


Great info Lynn.  

Wankel Germany Gmbh patented a wankel rotary with a water cooled e-shaft. 
Some day some one will build a rotary with silicon nitride high temp ball 
or roller bearings as used in NC machine tool spindles. They work to over 1000 F.

Perhaps Mazda came up with a new material for the 9500 RPM RX8 engine
or other changes like more clearance and a larger oil flow volume
with a larger oil pump.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org