Subject: Dry sump? RX8 press release intake air velocity.
From: ACRE NL
Date: 1/9/2002, 7:59 PM


is becoming closer to its tuned length what ever that is. As the
Mach
number goes
above about 0.45 Mach things start going down hill. 0.45 is a
magic
Mach number in
intakes and this number shows up in a lot of Taylor's work. If you
want lots
of power keep the Mach number less than 0.45 and that means larger
pipes
for more power at higher RPMs.


 The folks at Dynomation (www.dyonmation.com) say: "Port sizing has a
greater affect on engine performance than tuned runner lengths.
  Research has shown that maximum port velocity through the minimum
cross-sectional area of the runner should fall between 0.5 to 0.6 Mach, or
about 600- to 720-feet-per-second. Port velocities higher than 0.6 Mach
produce no further increases in volumetric efficiency."
 "If a broad power range is required, port areas should be sized so that
maximun engine speeds produce port velocities of about 0.75 Mach. This will
place optimum velocites (between 0.5 and 0.6 Mach) at lower engine speeds,
optimizing volumetric efficiency where desired. If high-speed, maximum power
is the goal, then port velocity at peak engine speed should be no higher
than 0.6 Mach."
  Dynomation offers 2 and 4 cycle simulations that are based on the
interactions of pressure waves and particle flow within intake and exhaust
systems passages. Too bad no rotary! Take a look at the demos, I think you
will be impressed.

Larry Wiechman

We don't care about broad power ranges in aircraft engines.
Peak HP is all that counts. Prop load is, at minimum, proportional
to RPM squared. When the prop tips get near supersonic the engine
runs into an immovable object.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org