Subject: Dry sump? RX8 press release intake air velocity.
From: ACRE NL
Date: 1/9/2002, 10:37 AM


 Well folks another nail in the coffin of high intake air velocity.

 Paul Lamar

 Hold on there Paul.  This is just another typical press-release mish-mash
statement.  It is the EXHAUST port area that went up 30%.   Intake port area
is not really affected.    You are so knowledgable about so many things that
it amazes me that you don't realize the key importance of intake air
velocity.

As always, I offer a $500.00 reward to anyone who can show proof that intake
air velocity is not important to intake system tuning.

Tracy Crook
tcrook@rotaryaviation.com
www.rotaryaviation.com


Here is a very good illustration from Taylor. This is volumetric efficiency as
a function of Mach number (Z) for a number of actual engines with a number of differnt 
intake manifolds and carbs. As you can see at lower RPMs the vol eff is increasing 
hence the power is increasing as the flow increases and as the intake pipe length 
is becoming closer to its tuned length what ever that is. As the Mach number goes 
above about 0.45 Mach things start going down hill. 0.45 is a magic Mach number in 
intakes and this number shows up in a lot of Taylor's work. If you want lots 
of power keep the Mach number less than 0.45 and that means larger pipes 
for more power at higher RPMs.

OK Tracy put the check in the mail NOW!!!

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org

Vol-eff-v-mach.gif