Michael MCP wrote:
I roughed out the port area and came up with 1-5/8" ID runners for the 6to4
end housing ports and 1-1/4" ID runners for the center housing
ports. These would merge into a 2-1/8 ID common runner. This would match
up to one side of a twin 55mm throttle body about right.
What was the size of the runners on the manifold casting?
Mike McGee, RV-4 N996RV, O320-E2G, Aurora, OR
13B in gestation mode
1-1/2 inch aluminum pipe with these dimensions. The center is 1-1/4 pipe.
You can get these bent from RB Wagner real cheap like $10 each.
They will also bend to smaller radiuses than some of the tube bending
shops like Burns Stainless.
Tom is putting about a 3/8 inch thick wall around these sizes so
you could port it out for larger tubing if you can find it bent
to your needs.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org