Subject: GAMI fuel injectors
From: ACRE NL
Date: 1/12/2002, 9:07 PM


I obtained a printed version on this chart and even
though it is supposed to be from the Continental IO-550 Operators
Manual there is a 1997 copyright claim by one George W. Braly
below the lower left corner. Obviously the chart is not from the
Continental IO-550 Operators Manual but is in fact a fabrication
by  one George W. Braly whom I suspect is the owner of GAMI.
Otherwise why would he copyright it under his own name.


A conspiracy!!!  Actually, what has happened is that George Braly has conglomerated various Continental IO-550 curves onto one chart for easy comparison.  As this chart is a "derivative work" by George, he is entitled to claim a copyright if he wishes.  George is affiliated with GAMI, but I'm not sure exactly how.  He's a talented engineer and a good guy.


Although it is unreadable on the GAMI web site version it clearly
states on the 8.5 by 11 printed version that this chart is
for 79% and 70% peak power. Continental dis allows leaning the
engine over 65% peak power. Therefore any BSFC calculations
made with the aid of this chart and assuming 50 degrees lean of
peak are invalid.

Continental and Lycoming test their engines at sea level from idle to 100% power at a variety of RPMs and mixture settings to derive their performance curves.  You've seen examples of this in the IO-550 chart I sent to you (the REAL Continental chart, not this derivative work) and the IOL-300 charts you sent to me.  Whether or not you should run your engine in this manner at low altitude is a different issue.

BTW, George's chart plots curves for 57%, 70% and 78% power.  Seems very clearly labeled as such to me.

Rick

The 57% curve is missing from the printed version. Obviously added later.

When I picked up my O-470-S at the Continental factory I got a tour.
Either Teledyne or Continental own Bendix. Bendix is the manufacturer of the mechanical
fuel injection used on Continental engines. I asked the technician if he 
matched the injectors for flow. He laughed and said of course. Not only 
were they matched the EGT/CHT was checked on the dyno runs for near equality. 
Apparently Continental has a set of dyno test baffles adjusted to cool 
each cylinder equally.

As an engine ages cylinders can deteriorate individually. This is 
usually caused by defective cooling baffles or leaking exhaust 
valves. In some cases just plane poor baffle design. 
Naturally this can cause differences in EGT and CHT cylinder to cylinder.
Replacing injectors on an old engine to try to fix it is not the thing
to do. This only works for a little while. Soon you will have differences
again. Then of course you will need to buy more injectors :-)>

BTW It amazes me that the engine guys leave the critical baffle details up to 
the AC manufacturer. They should wise up and supply properly designed 
molded fiberglas baffles that are finding their way on to the more 
advanced home builts.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org