OK, I'm not sure how I feel about this. It is hard to look at
this objectively when I
have spent my entire adult life considering intake flow velocity and
how to keep it
UP due to the demads of carburation. I THINK that I interprete
Taylor to mean
bigger is better, but only up to a certain point. AH, the devil is in
the details and the
only way I see to solve this is to experiment - on my list of things
to do when I get
the airplane flying.
However, no one has addressed exhaust gas dilution and how the
large ports
affect low speed/rpm operation - do not underestimate the importance
of this if you
are running a fixed pitch prop. The engine has got to idle in order
for the landing
task to be performed safely.
At low rpm the exhaust still contains enough high pressure to
backflow into the
intake since both the inake and the exhaust are open at the same time
(overlap).
This causes all kinds of problems such as lack of oxygen in the
intake charge, high
levels of CO(??) which tend to put the fire out, decreases the low
pressure of the
intake, and increases intake temp. I've probably forgotten something
important
here, but you can see the problem.
As stated above, large intake pipes means low velocity at these
low RPM's.
Small intake pipes mean higher intake pipe velocities and pressures -
these higher
velocites create inertia in the intake charge which blow past the
exhaust leakage
and maintain the low pressure of the intake port - these actions help
to decrease the
negative affects of exhaust dilution.
Ken Powell
The overlap of the periphery port and the bridge ported rotaries is not a
factor in very low speed performance. The driver has a habit of letting the
clutch all the way out just as soon as the car starts moving. This should be
the worst case for an overlap problem. There is no problem. The car just
drives away without protest, with a 2:1 first gear and a 411 rear gear. It
shouldn't, but it does. Under 500 RPM is my guess. It will only take a hint
of throttle at that speed but it does work just fine. The bridge port is not
quit as nice as the periphery port because the port closing is actually
later than the periphery port, but they both run fine very slowly with light
loads. Idle
(no load) for both is 2000 RPMs but even that can be slower, it just
sounds like hell.
Come in high. Slip it in and land. Who cares if the engine quits :-)>
How many people still do slips? Hold up your hands.
Lynn E. Hanover
I do. It is excellent training for emergency landings.
Paul Lamar
When the speed brake isn't enough, I slip the Long EZ. No flaps.
The Cessnas occasionally, but they have great flaps, so need it less
often.
Bill Freeman
Long EZ builder & pilot
BSME, MSME
EAA Technical Counselor
The neat thing about slipping is you can rapidly control your speed
and your decent rate. The response is near instantaneous while
electric flaps take awhile to move up and down. Another advantage
is you can slip at an speed without regard to the safe flap extension
speed.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org