Rick Girard
LEZ + 13B
P.S. I did come across something interesting in the 152 POH about
leaning. for
maximum economy the engine is to leaned to peak RPM and continue leaning
until RPM
drops 15 to 50 RPM! Variation is whether you have a Lyc O-235 L2C, N2C, or a
Cont. O-200. Sounds remarkably like lean of peak to me.
Peak RPM would be max power. Well rich of peak EGT.
15 to 50 RPM may still be rich of peak EGT.
Paul Lamar
Paul is right. Max power is richer than max EGT, you are still richer than
peak EGT.
What's really going on here is pretty different than it appears at first glance.
The mixture distribution is poor enough with any of the carburated aircraft
engines that on cylinder starts to lose power slightly. The other cylinders are
probably much richer, or at least, just the same. A friend's
Long EZ uses an Ellison carb and it has such uniform mixture distribution that
it will run smoothly until it just starts losing RPMs. You can lean it out, too
lean, so he has to be careful. I have a regular carb, so use the Cessna
technique and waste fuel on 3 of 4 cylinders.
Bill Freeman
Long EZ builder & pilot
BSME, MSME
EAA Technical Counselor
90% of the Cessnas out there I've seen have no EGT gauge,
so you are not going to get accurate control of leaning (and
thus BSFC). This is true of 152/172, maybe not of the larger models.
--
Perry Mick
Duckt N7XR
http://www.ductedfan.com
My 182 came with one probe down past were the three branches of the exhaust
manifold came together on the left side of the engine. Basically it was
measuring the average EGT of the left bank of cylinders. I now have six EGT
probes up closer to each cylinder. Also six CHT probes. Certified solid state
scanners like I have are very expensive and rare. If my friend, who manufactured
them, had not given it to me I would not have paid the several thousand
dollars they cost.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org