We'd love to build stratified charge engines. Anyone got $5MM laying around to help?
Jon
Is that all?
I believe that a medium displacement stratified charge engine can be designed, tooled, and taken to the prototype demonstrator stage for about $5 million. The larger the engine gets, the more difficult the development. (Very small is probably hard to do also, but I don't think anyone wants something lawnmower sized.) Curtiss-Wright/Deere/RPI worked under government contract, which adds quite a bit of cost for things that are not directly related to the product (not necessarily bad things, but perhaps less necessary for a "lean" commercial effort). The overhead structures at the companies were also very, very high. I think the marine and aviation engines would have similar base ratings -- say 400 hp at 5000 RPM? I think we already have some of the capabilities within the folks on the list, plus a few others. This could be done as a "virtual company," with a lot of CAD drawings flying through the ether...
Anyone game?
Jon Lauter
Rotary Power Marine Corporation
Starting with a Mazda I hope. I have a few ideas.
As the rotor comes up to top dead center the squish area on the trailing side
gets smaller and some mixture squishes out of there. If the rotor could
be grooved in such a way to squish the mixture in a way that concentrate it towards
the spark plug the natural stratified charge of the rotary might
be enhanced. Some sort of glass rotary engine could be made to
high speed photograph the ebb and flow of the mixture during this phase.
Not one that runs of course. Just for the purpose of studying the
aerodynamics in the compression and combustion chamber.
Perhaps a bit of high pressure fresh air could be injected at
just the right time in this small volume squish area to purge it of
fuel rich mixture. Nothing burns in there anyway.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org