Subject: low oil pressure
From: ACRE NL
Date: 1/15/2002, 7:48 AM


Al Fuller wrote:

OK guys - I have a question [not strictly rotary related].

In one of my cars, ['62 Austin Healey] the oil pressure starts off high,
but drops steadily as the car warms up, to the point where it shows only 25
lbs at highway cruise [should be double that].

I changed the oil [Castrol 20W-50], with the same results.

I would think the engine would be knocking or making noise with this low
oil pressure, but it does not.

So, what might cause this?  Oil pressure relief valve?

Thanks, Al.


The oil pump is worn out. Or, the bearings are worn out. Or, the oil pressure relief plunger spring has gone a bit soft. Or, a piece of debris is stuck in the plunger seat. Or the oil pickup tube is coming loose from the pump. Or, a combination of the above up to and including all of the above. I used to race Spitfires and GT-6s so I am familiar with farm tractor motors.
The 25 pounds is enough for touring. So long as it dosn't get worse, and you don't buzz the engine. I would take off the pan and check (replace)the pump. I would shorten the pump body to get .010" end clearance on the gears (gerotor).Just lap it on a ciece of wet and dry paper on a piece of glass. Lap the pump cover if it is scratched. I would replace the bearings just for drill but plastigage them first just to see what the clearance is now. You can do this from the bottom between sessions (20 minutes)with practice. Do the rods first then loosten the main cap bolts to get a few thousands clearance, and do the mains. Just push on the side of the bearing away from the tab with a screw driver,and rotate the bearing around the crank with a sharp pick. Keep something thicker than yourself with you under the car. They are very heavy.
Lynn E. Hanover

The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org