<<<snip>>>
Any ideas on securing just the motherboard, it's ATX
power supply with inverter, DVD drive, and hard drive withoug the heavy
case?
Thanks,
AI Nut
<<<more snip>>>
Throw away the PC steel case. You don't need it. The mother board weighs
less than a pound. A solid state +5 volt DC to DC converter
should also be less than a pound. What is left is the 3.5 inch hard disk.
Everything else can stay back in the shop. Well maybe not the display
and the keyboard. What display are you using? The color flat panel displays
I have seen are about 5 pounds with a 12 Volt brick which you won't
need in the airplane.
Paul Lamar
<<<snip of more good stuff>>>
2 questions:
1. How does one secure the mobo, drives, and power supply without the
case? Bolting or riveting them onto the airframe is very problematic.
Just copy a steel case case in aluminum sheet and rivet it together.
Some of the best stuff to make it out of is 1/4 inch thick
aluminum honeycomb panels. A bit hard to find if you have no
aircraft surplus stores in your town. A couple of guys on here
live near Boeing and P&W. Not totally necessary however. Plain
sheet aluminum works OK. Once you get all the parts on the bench
you can move them around to see what fits where in the most compact
arrangement.
2. Where does one find the 12V to 5V dc converter that I keep hearing
about? Google searches produces wild results. The only promising one
was a circuit layout that we had to build. All others that seemed even
halfway useful were many hundreds of dollars. 8-(
AI Nut
There are lower cost versions out there.
Anyone of a number of suppliers. Go to google.com and put in
DigiKey, Mouser, Newark Electronics and Allied Electronic. Then search for
DC to DC converters. What you want is something that takes in
8 to 20 volts DC and puts out 5 volts DC regulated with at least 3 amps or more
output current. You may need something that puts out -5 volts and -12 volts but
those DC to DC converters are much cheaper as the out put current required
is on the order of only about one or two tenths of an amp.
All of this still beats the cost of a new notebook computer.
You could buy an old used notebook that would run DOS fine.
I am not familiar with the going rate for used notebook
computers but I am willing to bet they can be had for less than
$500.
Here is a picture of one I made back in the late 1980s.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org