Archie wrote:

Perhaps we can talk you into doing some 13B stuff on the older dyno
Archie. I could come up there and volunteer the labor.

Paul Lamar

I have no dyno experience with the Rotary, and had been in contact
with Paul Yaw regarding adapters, programming, etc.
The older dyno has been sold to help finance the new. ($26k projected)
I expect to be without for another two months, largely due to
a backlog of work.
When ready for a rotary, I would welcome some expertise.
How about a healthy 4 rotor to start?
Archie

Those are rare animals Archie. As I recall there was one in a race car
for sale. They were asking one million as I recall for the whole works.

Paul Lamar

If Bruce can build a one rotor, then he can build a 4 rotor.

Hans

Yes I think you are right Hans.  He will need two of those special
three rotor intermediate housings. With the right machine tools a four rotor
shaft should not be that hard to make.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org