Apples and oranges here Mark. Anti-lock Braking Systems work off hyd
pressure.
You are looking at probably a 1000 psi or more hyd pressure pump. Might be
good for getting your landing gear up and down but I doubt it.
Probably low volume low HP.

Paul Lamar

Auto Anti lock systems are supplied pressure from your foot and the master
cylinder, they just modulate that pressure to keep the wheel from skidding.
Same with large aircraft anti-skid.

It should be considered more of a solenoid valve than a pump. I suppose
there could be a hyd pump, but it would take a significant amount of time to
achieve pressure if it was the size that would fit under a car hood, and
would take a boatload of current.

Several friends and I are looking into the GM electric smog pumps. About
$100 new from what I can tell; on most vehicles with LS-1 engines.

Of course we want them so our cars can pass emissions :)

Mike Harrington

The only way you can modulate hyd pressure to the brake cylinders 
is to bypass some of it back to the master cylinder reservoir. 
This bypassed fluid must be replenished at high pressure somehow 
when needed or your foot will slowly sink to the floor.

I does not take a large pump as we are talking about a very small volume
of fluid.

I am open to hearing about another way of doing it. 

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org