Marc Wiese wrote:
The 1996 corvette GM 12v electric motor driven air pump I have
weighs just 2 lbs, 4 oz. I have no idea what amount of air it will
supply yet.
Marc Wiese
OK, more information, not much good. The 12 volt plastic body airpump
(from 69 vette) weighs 2 lb 10 oz with stock 3 wire connector. It is gm
pn 24505066.
When it is running (in my test) the cast part got very hot. Perhaps it
only runs when the car is idling. In any case, the built in clutch
(on-off switch) seems to draw 1.6 amps. The start up motor current is 13
amps, running it is settling at 10 amps-runs all the time. Admittedly,
my transformer was at its limits running this thing on my bench. Perhaps
a bigger DC power supply would work better (I'll try on the running car
battery later-I don't think it should get this hot, maybe it is bad). In
any case, with the jury rigged tubing, and the automotive Sears vac
gauge, I get lots of flow, but little vac. Maybe 2" HG at most, but it
ran my old autopilot DG ok, just took some time to spool up. And I did
have it drawing thru very small tubing into large tubing at the pump, if
it makes a difference?
I think it is built to supply air, not vac, and in copious amts at low
rates (air injection to manifold and cat probably).
I have my doubts that this would be a continuous duty item. Maybe for
emergencies as a low cost alt vac supply. Pictures attached of pump.
Marc Wiese
Good work Marc. Thanks.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org