Well, after months of rebuilding motor mount pieces and lots of
input from the guys here on the list, I am finally finished with my
RV-4 motor mount. Note that this mount is for a PP motor so I had a
little more flexibility on the left side of the engine since there
is not a 4 or 6 port intake manifold to make things more difficult.
Special thanks to Paul, Mike Wills and Monty Roberts for their
input. The advantages of this mount is that for a narrow single
place or tandem aircraft there is much more room under the engine
for radiators and exhaust; the value of this cannot be
underestimated unless you have tried to fit all of this stuff in a
24" wide cowling! Pictures are attached.
Ken Powell
Looks like it will work fine Ken. Glad to see you supported the upper
truss in the vertical plane. Good way of doing it. The only thing I
can see to watch is a little local bending in the connection between
the rubber bushing brackets and the rectangular cross tube. Got any
detail sketches on that? What does it weigh?
Paul Lamar
The original conical mount from Van's weighed 11 lb 6 oz. The new mount
weighs 13 lb 3 oz, or 1 lb 12 oz more. Lot's of extra .75" tubing there!
The engine adapter mounts weighed a total of 5 lb 12 oz. The lower mount
weighed 2 lb 12 oz, the right upper weighed 1 lb 11 oz and the upper left mount
weighed 1 lb 12 oz. The three adapter mounts were weighed together as well as
individually to eliminate rounding errors. Note that the upper adapter mounts (on
both sides) tie the front and rear of the engine together to eliminate extra loads on
the tension bolts.
Ken Powell
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org