Subject: turbo exaust manifolds
From: ACRE NL
Date: 1/27/2002, 1:34 PM


We are in a quandry about the correct exaust
manifold for our GEN 3. We read the stock ones
crack, the stainless ones crack, the iron ones are
heavy... which way to go?
What works, what lasts and what about performance?
...Chrissi

I assume this is for a turbo version of the gen 3.
Did Greg Richter say his off the shelf  after market
HKS TO4 turbo
manifold cracked?

The 1989-92 stock Mazda cast iron turbo manifold
does not crack in automotive
service, it will fit the gen 3 and it is not that
heavy as I recall
because it is small. See the picture below.

If you can afford it Inconel is the ultimate way to
go.

Performance does not seem to be that big of an
issue. The turbo
is capable of generating way more power than the
turbo and the engine
can tolerate for long periods of time. People have
got 800 HP out
of a 13B for drag racing with a simple turbo exhaust
manifold.

The big question we have now is; how much boost can
you run continuously
and for how long? Greg is our guinea pig.

We discussed this for years off and on and it is all
on the CD.

Paul Lamar


 question- if the turbo fails, is it on the exhaust
or compression side ie will the engine injest parts
and if it will, any solutions    jim coffman

I think what you will first notice is an exhaust leak
from cracks in the turbine housing or manifold.

The compressor rarely fails unless it is over speeded.
In that case the turbine is more likely to fail first
from overspeed as the tensile and fatigue strength of the turbine
material is greatly degraded by the high heat.

Someone once told me a turbo is self regulating to a 
certain extent. If you try to force too much heat through
it the blades will melt around the edges and the turbo will
slow down.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org