Subject: rotary heat balance - new address
From: ACRE NL
Date: 1/28/2002, 1:08 PM


Paul - Scientific curiosity - trying to pin down
the reason for high exhaust temp. I cannot
believe that it is unburned fuel, if so the
Bsfc would be significantly worse, and the
emmissions outrageous. I suspect that it might
be the lack of charge flow reversal, and reduced
heat transfer to the internal exhaust passages.

However, this would reduce the heat rejected
to the coolant, and you seem to indicate that
coolant heat is high. Is the coolant (oil
 included) higher per Bhp than a piston engine?

Thanks - always enjoy rattling sabers with you.
Vance

The early opening of the exhaust ports has also been identified
as a factor. The RX8 will have later opening exhaust ports
to lengthen the expansion cycle.

Note: The second chart is the low HP heat balance
at only 80 Km per hour. 54 MPH. 
The first one is full load.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org

heat-balance-diag2.jpg

heat-balance-diag3.jpg