Thanks Mike I was just trying to nail down a
possible operational reason
for turbo cracking. A couple more questions if
you don't mind.
How many miles on the car when you bought it?
145,000-ish. Car was down on bost a little when I
got it, but not too bad
(~8 PSI).
I assume OE means Original Equipment correct?
What did the OE manifold cost?
Yes, and it was about $260 from Mazda Competition
Parts
What are the claims for Jethot 2000? Is it
claimed to reduce
cracking?
No, it is a ceramic coating designed to keep the
heat inside the manifold
instead of radiating. Supposed to increase
efficiency, but the heat
reduction underhood is the bigger benefit IMHO. It
is applied both inside
and outside. Had this done on my downpipe (see
last question) and the
resulting heat reduction was incredible. Also
inhibits rust. The 2000
moniker is just for the temp rating - can't use
the girly stuff on a rotary
(no offense meant, Chrissy). BTW, after close to
15K miles on the downpipe
with jethot 2K it looks just like new inside and
out.
Do you have any data that might explain turbo and
manifold cracking
as a function of back pressure or possibly a
plugged precat?
Is the replaced precat gutted. Send me private
email if you want
on this last question :-)>
Investigative data only. Precat was thoroughly
plugged, and was keeping
boost down around 4 PSI or so. I replaced it with
a Racing Beat 2.5"
downpipe and modified the stock cat to fit
(basically had 3" of pipe welded
on the front side of the cat). Boost went back to
10 PSI. This is from a
known accurate guage BTW, not the stock on-off
boostometer.
I should have recognized that I had an exhaust
leak too, but I didn't add it
up until the motor was out: exhaust markings on
the rear housing, burnt
paint on hood underside (thought this was due to
precat heat), extreme wire
embrittlement.
When the water Oring went, but wasn't bad enough
to mean I couldn't drive it
yet, I replaced the main cat with a 2.5" 'test
pipe' just to have some fun.
Got max of 12 PSI in 4th at speed, with no
detonation. Did get a little bit
in 2nd and sometimes 3rd, usually at light load in
traffic. When motor was
disassembled, there was no major wear except for
the broken Oring land,
stationary bearings were out of spec, and the
front and rear housings had
too much stepped wear. Intermediate housing and
rotor housings were fine and
are being reused. Rotors and apex seals were fine
too, although the apex
seals were worn past the point where I would be
comfortable reusing them.
But for a backup racecar motor they will work just
fine. :)
Mike Harrington