Subject: EE type question for 12A motor distributor
From: ACRE NL
Date: 1/29/2002, 5:32 PM


Hi everyone, I have a 12A carburetted motor that I have converted the
leadings to direct fire a la 2nd generation coil/igniter assembly, however I
would like to also convert the trailings. Problem is of course that while I
can fire the leadings waste spark, I can't do that with the trailings. The
2nd gen trailing coil used a on/off input to indicate whether rotor 1 or 2,
that was generated by the ECU.

I am wondering, is there any (relatively) easy way to make a circuit to do
the same from the dizzy output? IE, flip-flop triggered by a low voltage run
across the cap & rotor? This seems like it should work but I'm not sure what
kind of signal level I'd get from that.

For the leadings, I went into the dizzy and added some new wire and a
connector to where the leading igniter plug used to be. Ran those to the 2nd
gen igniter input, works good long time. For the trailings though I can't
think of a way to easily differentiate between 1 and 2 just looking at the
hall-effect sensor.

I do have a spare dizzy that I can alter to try suggestions and would be
glad to try anything.

Thanks!

Mike Harrington

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org