Subject: 12A rotor gear failure
From: ACRE NL
Date: 1/31/2002, 9:56 PM


<< Lynn was that 12A rotor gear that failed a special Mazda Competition
 hardened gear with 12 roll pins or was it a stock
 12A un-hardened gear with nine roll pins?
 At what RPM did the failure occur?

 Paul Lamar >>


That was a stock rotor and gear. The hardened front stationary gear lost two
teeth and set it off. The rotor lost almost all of the teeth. It was hard on
the budget. We were running an RX-2 because somebody gave me the car with a
bad motor in it.
Towing on an open trailer with a 68 Chevy 6 cylinder van/hotel. Our tools
were a hatchet a pair of pliers and lots of tape.

I don't think we run hardened rotor gears even in the store bought engines.
It is probably a must in an endurance engine. The duty cycle is not that long
and the races are only about 40 minutes. The rule in fact is 45 miles or 45
minutes is a completed race. We run almost no flywheel mass and a small one
groove aluminum front pulley. This is very hard on the gears.
I think in a steady state situation as in the airplane, with a bit of mass
like the coupling for the PSRU and a stock front pulley there would never be
a problem with the stock gears.
Lynn E. Hanover

I loved my RX2. Great little car.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org